stage moveto This command can be used to move the head stage to a specific position at a specified speed. You must enter a destination either in motor steps or in microns, if you use microns then you must follow the value with " um" or it will be treated as steps. After specifying a destination you may optionally specify a speed, either SLOW, MED, or FAST. These speeds are setup in the "aldrv #" nvs subsystem. The ThermoFlex uses aldrv 1. None. ThermoFlex stage moveto dest [ "um" [speed]]

../commands/stage.xmlCommand: stage

../commands/stage_stop.xmlCommand: stage stop

../commands/stage_init.xmlCommand: stage init

../commands/stage_install.xmlCommand: stage install

../commands/stage_getfocus.xmlCommand: stage getfocus

../commands/stage_zero.xmlCommand: stage zero

../commands/stage_home.xmlCommand: stage home

..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:39:25 2008 PST